Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 96)

Chapter 4 Installation and Wiring
4-17
(4) Attach the USB cover to attach the USB cable. Insert the USB cover into the tab of the USB holder.
„ Removal
(1) Lift up the tab of the USB holder and then remove the USB cover as shown below.
(2) After removing the USB cable, remove the picks pushing the USB holder from both top and bottom.
• Check the up/down orientation of the USB cover to ensure that the USB cable is
secured properly.
USB Cover Tab
ST-3200 Series ST-3400 Series
USB Cover
Tab
USB Holder
USB Cover Tab
ST-3400 Series
USB Cover
Tab
USB Holder
ST-3200 Series