Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 85
Advertising
ST3000 Series Hardware Manual
4-6
(3)
Insert each of the fasteners as shown
below. Be sure to pull the fastener back
until it is flush with the rear of the
attachment hole.
(4)
Use a Phillips screwdriver to tighten each
fastener screw and secure the ST in place.
• Tightening the screws with too much force can damage the ST unit’s plastic case.
• The torque required to tighten these screws is 0.5 N•m.
Advertising
This manual is related to the following products: