Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 93)

ST3000 Series Hardware Manual
4-14
4.3 CF Card Insertion/Removal
This section describes how to insert and remove a CF Card.
When using the ST Unit and a CF Card, observe the following precautions:
4.3.1 Inserting the CF Card
Use the following steps to insert the CF Card in the ST.
(1) Pull the CF Card Cover frontward and then open it upward.
Prior to inserting or removing a CF Card, be sure to turn the ST unit’s CF Card ACCESS
switch OFF and to confirm that the ACCESS lamp is not lit. If you do not, the CF Card’s
internal data may be damaged or lost.
While a CF Card is being accessed (Status LED: Blinking in green), NEVER turn OFF or
reset the ST, or insert or remove the CF Card. If you do, the CF Card’s internal data may be
damaged or lost.
Prior to inserting a CF Card, familiarize yourself with the CF Card’s front and rear face
orientation, as well as the CF Card connector’s position. If the CF Card is not correctly
positioned when it is inserted into the Multi Unit, the CF Card’s internal data and the ST unit
may be damaged or broken.
Be sure to use only CF Cards manufactured by Pro-face. The CF Card’s internal data may
be damaged when using another manufacturer’s CF Card.
Once ST data is lost, it cannot be recovered. Since accidental data loss can occur at any
time, be sure to back up all ST screen and CF Card data regularly.
Be sure to follow the instructions given below to prevent the CF Card’s internal data from
being destroyed or a CF Card malfunction from occurring:
• DO NOT bend the CF Card.
• DO NOT drop or strike the CF Card against another object.
• Keep the CF Card dry.
• DO NOT touch the CF Card connectors.
• DO NOT disassemble or modify the CF Card.