Yokogawa DAQWORX - Manual (Page 26)

2-6 IM WX101-01E
4. Input a project name and select an operation level; then click “OK.”
For more details about the operation level, see “Setting Operation Level to a Project”
in section 2.5.
Note
• You cannot use the following characters in a project name: \ / : , ; * ? ” < > |.
• The following character combinations cannot be used as project names.
con, prn, aux, aux1, aux2, com1, com2, com3, com4, com5, com6, com7, com8, com9, nul,
clock
• You cannot create a new project with the same name and operation level as that of an
existing project. You can create a new project with an existing name if its operation level is
different.
5. If you wish to set password protection, carry out the operation described in “Setting
Password Function” in section 2.5.
6. Sets the logger auto start function. Select “Off,” “Only scan measurement data,” or
“Scan and record measurement data.”
Note
In the logger auto start function, you can select “Only scan measurement data,” “Scan and
record measurement data,” or “Off” when starting the Manager.
Selecting an Existing Project
To select a project when more than one project has already been created, do the
following.
Procedure
1. Same as the operation in “Creating a New Project.”
2. Same as the operation in “Creating a New Project.”
3. In the “Project” list box, select the project.
4. If “Use Password Protection” has been checked for the selected project, the “Input
Password” dialog box appears.
5. Type the password and click “OK.”
You cannot open the project if the password does not match.
2.4 Setting a Project