Yokogawa DAQWORX - Manual (Page 47)

2-27 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Configuring the DAQLOGGER
2. Click the “Auto Assignment” button or, in the menu bar, select “Edit” then “Auto
Assignment.”
The recorder and channel numbers are assigned automatically according to the
instrument settings entered in the Software configurator. Tag numbers are assigned
starting with Tag No. 1 in the following order: measurement channel 1 on recorder
number 1, computation channel 1 on recorder number 1, internal loop channel 1
on recorder number 1 (CX only), external loop channel 1 on recorder number 1,
measurement channel 1 on recorder number 2…and so on.
Auto Assignment button
3. Click the check box of “Use” cell to switch the Use/Not Use of the tag.
Clicking the tool cell in the bottom enables the Use/Not Use of the tags in the
selected area to be collectively switched.
To edit each item of the tag information that has been automatically set, perform the
following procedure.
• Manual settings operation
A. If necessary, change the tag name.
A tag name of up to 32 characters long can be entered.
Clicking the tool cell in the bottom renames the tag names of a selected area. Taking
the first tag name as a base form, the following tag names will be renamed in the
form of “TagName-nnnn” (nnnn: a number which increments by 1, see page 2-21).
B. If necessary, click the “Recorder Number” cell and select the recorder that is to be
assigned to the tag from the list box.
The recorder numbers appear in the list box are as shown below. However, recorder
numbers not connected using the Software Configurator do not appear in the list
box, so you cannot select them.
• NONE
• R01: model name to R32: model name
2.7 Setting Tags