Yokogawa DAQWORX User Manual
Page 99
3-21
IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Using Data Monitor
3. In the “Log” tab panel (alarm log display) of the alarm monitor, drag the mouse from
one line to another.
The cursor’s values at the start and end points of the selected area are displayed in
the “Cursor’s Value” dialog box.
Values at the start and end points of the selected area are displayed.
Clearing the Cursors
To clear the cursors, perform the operation shown below.
However, cursors will disappear without doing the following operation when the monitor’s
display updating is resumed.
Procedure
1. From the menu bar, select “View” then “Hide Cursor.”
When the cursors are cleared, no data is displayed in the “Cursor’s Value” dialog
box’s table.
Note
The “Cursor’s Value” dialog box disappears when the monitor’s display updating is resumed.
3.4 Using the Cursors