ADTRAN 1000R Series - Manual (Page 1341)

Command Reference Guide DHCP Pool Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1341
ntp-server <ip address>
Use the ntp-server command to specify the name of the Network Time Protocol (NTP) server published to
the client.
Syntax Description
<ip address> Specifies the IP address of the NTP server.
Default Values
By default, no NTP server is defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 9.1 Command was introduced.
Usage Examples
The following example specifies the IP address of the NTP server:
(config)#ip dhcp pool MyPool
(config-dhcp)#ntp-server 192.168.1.1