Arp arpa – ADTRAN 1000R Series User Manual
Page 616
Command Reference Guide
Ethernet Interface Configuration Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
616
arp arpa
Use the arp arpa command to enable address resolution protocol (ARP) on the Ethernet interface.
Syntax Description
arpa
Sets standard address resolution protocol for this interface.
Default Values
The default for this command is arpa.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and Total Access
900 Series units.
Command History
Release 3.1
Command was introduced.
Release 5.1
Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.
Usage Examples
The following example enables standard ARP for the Ethernet interface:
(config)#interface eth 0/1
(config-eth 0/1)#arp arpa