ADTRAN 1000R Series - Manual (Page 562)

Command Reference Guide ADSL Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 562
ADSL I NTERFACE C ONFIG C OMMAND S ET
To activate the ADSL Interface Configuration mode, enter the interface adsl command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface adsl 0/1
(config-adsl 0/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
retrain on page 563
snr-margin [showtime monitor | training monitor] <margin> on page 564
training-mode [G.DMT | G.LITE | Multi-Mode | T1.413] on page 565