ADTRAN 1000R Series - Manual (Page 578)

Command Reference Guide DDS Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 578
DDS I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the DDS Interface Configuration mode, enter the interface dds command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface dds 1/1
(config-dds 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock rate [auto | bps56k | bps64k] on page 579
clock source [line | internal] on page 580
data-coding scrambled on page 581
loopback [dte | line | remote] on page 582
remote-loopback on page 583
snmp trap on page 584
snmp trap link-status on page 585