Traceroute <address – ADTRAN 1000R Series User Manual
Page 25
Command Reference Guide
Basic Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
25
traceroute <address>
Use the traceroute command to display the Internet Protocol (IP) routes a packet takes to reach the
specified destination.
Syntax Description
<address>
Specifies the IP address of the remote system to trace the routes to.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Command was introduced.
Usage Examples
The following example performs a traceroute on the IP address 192.168.0.1:
#traceroute 192.168.0.1
Type CTRL+C to abort.
Tracing route to 192.168.0.1 over a maximum of 30 hops
1 22ms 20ms 20ms 192.168.0.65
2 23ms 20ms 20ms 192.168.0.1
#