ADTRAN 1000R Series User Manual
Page 314
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
314
show vlan [brief | brief realtime | id <vlan id> | name <vlan name> |
realtime]
Use the show vlan command to display current virtual local area network (VLAN) information.
Syntax Description
brief
Optional. Shows an abbreviated version of the VLAN information (brief description).
brief realtime
Displays full-screen output in real time. See the Functional Notes below for more
information.
id <vlan id>
Optional. Shows information regarding a specific VLAN, specified by a VLAN interface
ID (valid range: 1 to 4094).
name <vlan name>
Optional. Shows information regarding a specific VLAN, specified by a VLAN interface
name (up to 32 characters).
realtime
Displays full-screen output in real time. See the Functional Notes below for more
information.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1
Command was introduced.
Release 10.1
The real time display option was introduced.
Function Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to