Agilent Technologies 16700 - Manual (Page 63)

63
Post-Processing and Analysis Tool Sets
Serial Analysis
...accept the default
start of frame label
“Start” or modify the
label to a name of your
choosing.
...specify the pattern
that designates the start
of a frame.
...get immediate feed-
back as you configure
the tool set for your
data. This diagram
changes as you make
your framing and data
block selections.
...remove stuffed 0s or
0/1s from the trace
before other serial
analysis functions are
performed. Some proto-
cols use bit stuffing to
maintain clock
synchronization.
...specify the portion of
the data block for the
serial-to-parallel
conversion.
...specify whether the
end of frame occurs at
the end of a data block
of X bits or on a speci-
fied pattern.
...accept the default
end of frame label
“End” or enter a
different name.
To Separate Frame Information
from the Data Block . . .
Figure 5.17.