Edwards Signaling EBPS Remote Booster Power Supply - Manual (Page 8)

2 Remote Booster Power Supply Technical Reference Manual
Installation procedure checklist
Follow these steps to install and set up the booster power supply (BPS).
 Verify that all power and field wiring are de-energized before proceeding.
 Unpack the equipment.
 Review the “Getting started” section.
 Review the applications: Review the applications to determine how you want
to use the BPS. See the “Applications” section.
 Prepare the site: Make sure the installation location is free from construction
dust and debris and extreme temperature ranges and humidity.
 Install the enclosure: See “Installing the enclosure” for enclosure dimensions.
 Install option modules if required: See “Installing option modules in the
enclosure.”
 Install the 3-TAMP tamper switch (if one is used): See “Installing the 3-TAMP
tamper switch.”
 Set the jumpers: See “Setting the jumpers.”
 Set the DIP switch options: See “Setting the DIP switches.”
 Review wire routing: See “Wire routing.”
 Check field wiring for shorts, opens, and grounds.
 Connect the field wiring: See “Connecting the field wiring.”
 Turn on the AC mains power.
 Connect the battery compliment.
 Verify that no defaults are displayed.
 Test the system for proper operation.