Fire-Lite UDACT-F Universal Digital Alarm Communicator Transmitter - Manual (Page 46)

Troubleshoot Mode
46
Document #50049 Rev.E0 1/22/01 P/N 50049:E0
4.3 Troubleshoot Mode
To enter Troubleshoot Mode, press the MODE key. Enter the code 8768 and press the [ENTER/STORE] key.
☛ 8768 spells TROU on a Touch-Tone ® phone.
Once in Troubleshoot Mode, the UDACT-F will:
• transmit the 'UDACT-F Off Normal' message to the Central Station(s)
• continue to communicate any events not yet acknowledged at the Central Station prior to entering
Troubleshoot Mode
The Up arrow, Down arrow and 1st Event keys do not function in this mode.
Telephone Line Testing
Pressing C for touchtone dialing or D for rotary dialing, followed by [ENTER/STORE] causes seizure of the Pri-
mary phone line, which in turn, lights the red LED signifying Primary phone line active. After a delay of three sec-
onds, the UDACT-F goes off-hook to acquire a dial tone.
The UDACT-F keypad may be used as a telephone touchpad for number dialing. Once the first digit is pressed, the
display will move the C or D character one position to the left, while placing the digit to be dialed on the farthest right
display position. Continue to enter the phone numbers to be dialed. Successive depressions of the [ENTER/
STORE] key hangs up and picks up the phone (places the phone on or off the hook).
The secondary phone line may be tested by pressing the E key for touchtone dialing or the F key for rotary dialing
and then following the same procedure used for the primary phone line.
A handset may be temporarily connected across transformer T1 as indicated in Figure 4-2. The handset, when con-
nected across T1, may be used only as an amplifier/speaker or telephone with the UDACT-F used for number dialing.
4.4 Lamp Test Mode
To perform a Lamp Test, press the MODE key and then enter the code 5267. Next, press the [ENTER/STORE] key
to test all system LEDs. The LEDs will stay on for five seconds, then the UDACT-F will return to Normal Mode.
☛ 5267 spells LAMP on a Touch-Tone ® phone.
FIGURE 4-2: Handset/Speaker Connection
Both Primary and Secondary Lines