KYORITSU 3128 - Manual (Page 27)

KEW3128
23
KEW3128 6. Measurement
6.1.2 Steps for Measurements
Insulation Resistance Measurement
① Check the voltage which can be applied to the circuit under test,
and set the Range Switch to any desired Voltage Range.
② Select the “IR” (Insulation Resistance) on the Mode Selection
Screen, and press the ENTER Key.
The instrument gets started with the previously selected mode, and enters
into the stand-by mode.
③ Set a voltage value, and confirm it with the ENTER Key.
④ Confirmation Screen is displayed. Press the ENTER Key and
confirm the value.