Metex SharkTX Multi-Parameter Transmitters - Manual (Page 26)

pH - Setup Menu - Display Damping 4.11 Page 24
MULTI-PARAMETER TRANSMITTER USER’S MANUAL
pH - Setup Menu - Display Damping 4.11
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
UP
DOWN UP
DOWN
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
The Display Damping menu allows the user to adjust
the rate at which the display and the output is
updated. This allows the user to dampen out
unstable process readings.
The damping can be set from 0 seconds to 10
seconds. (default value is 0 sec.)
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the Display Damping
Menu. This function is useful if you wish
to view the current selection without
making any changes.
Not stored
RUN MODE
Use the and to adjust
the damping time, the default
setting is 0 seconds.
The setting can be adjusted from 0
to 10 seconds.
Then press the key to store the
selection and return to the Display
Damping Menu.
Stored
If you wish to save the setting, press the
key to highlight the Y character
Press the key once
which will move the cursor back
to the RH side of the display.
Press the key to accept the
setting and move to the store function
Press the key once
which will move the cursor
over the seconds digit
STORE? Y N
UPDATE 10 SEC >
UPDATE 0 SEC >
DISPLAY DAMPING
UPDATE 1 0 SEC >
DISPLAY DAMPING
DISPLAY DAMPING
DISPLAY DAMPING
STORE? Y N
DISPLAY DAMPING
7.15pH 25.0C
CALIBRATION
SETUP
UTILITIES
DISPLAY DAMPING
AUTO RETURN
T.COMP OVERRIDE
DISPLAY DAMPING
UPDATE 0SEC >
TEMP UNIT
PROBE SELECTION
DOWN
TEMP SENSOR