Metex SharkTX Multi-Parameter Transmitters - Manual (Page 73)

MULTI-PARAMETER TRANSMITTER USER’S MANUAL
Flow - Setup Menu - Display Damping 7.7
Flow - Setup Menu - Display Damping 7.7 Page 71
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
UP
DOWN
DOWN
DOWN
DOWN
DOWN
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the Display Damping
Menu. This function is useful if you
wish to view the current selection
without making any changes.
RUN MODE
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
If you wish to save the setting, press the
key to highlight the Y character
Stored Not stored
DOWN
Then press the key to store the
selection and return to the Display
Damping Menu. DOWN
DOWN Press the key to accept the
setting and move to the store function
Press the key once
which will move the cursor
over the seconds digit
The Display Damping menu allows the user to adjust
the rate at which the display and the output is
updated. This allows the user to dampen out
unstable process readings.
The damping can be set from 0 seconds to 10
seconds. (default value is 0 sec.)
Press the key once
which will move the cursor back
to the RH side of the display.
Use the and to adjust
the damping time, the default setting is
0 seconds.
The setting can be adjusted from 0 to
10 seconds. UP DOWN
DISPLAY DAMPING
AUTO RETURN
UNITS OF VOLUME
UNITS OF TIME
TOTAL 0
CALIBRATION
SETUP
UTILITIES
DISPLAY DAMPING
UPDATE 1 0 SEC >
UPDATE 10 SEC >
DISPLAY DAMPING
STORE? Y N
DISPLAY DAMPING
DISPLAY DAMPING
STORE? Y N
UPDATE 0 SEC >
DISPLAY DAMPING
UPDATE 0 SEC >
DISPLAY DAMPING