Metex SharkTX Multi-Parameter Transmitters - Manual (Page 71)

MULTI-PARAMETER TRANSMITTER USER’S MANUAL
Flow - Setup Menu - Units of Time 7.5
Flow - Setup Menu - Units of Time 7.5 Page 69
DOWN UP
DOWN
DOWN DOWN
DOWN
UP
UP
UP
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
Then press the key to store the
selection and return to the UNITS OF
TIME Selection Menu.
Press the key to accept the
setting and move to the store function
The Units of Measurement is broken into two variables, UNITS OF VOLUME and UNITS OF TIME. The two variables
are then combined to display the desired units of measure. For example, if units of Volume is to set Cubic Meters (CM)
and Units of Time is set for Seconds (S), the controller will display flow as Cubic Meters per Second on the front LED
display.
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
Not stored
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the UNITS OF TIME
Selection Menu. This function is
useful if you wish to view the current
selection without making any
changes.
the Y character.
Or press the key to highlight
Stored
UNITS OF TIME
The user can select from four predefined Units of Time, Seconds, Minutes, Hours, Days.
RUN MODE
Press the key once
which will move the cursor
over the last character of the
time unit setting.
DOWN
DOWN Use the or keys to
scroll through the available ranges
UP
TOTAL 0
SETUP
UTILITIES
CALIBRATION
UNITS OF TIME
STORE? Y N STORE? Y N
UNITS OF TIME
HOURS H >
DAYS D >
MINUTES M >
SECONDS S >
UNITS OF TIME
UNITS OF TIME
UNITS OF TIME
UNITS OF TIME
SECONDS S >
UNITS OF TIME
UNITS OF TIME
UNITS OF VOLUME
MINUTES M >
UNITS OF TIME