Metex SharkTX Multi-Parameter Transmitters - Manual (Page 62)

MULTI-PARAMETER TRANSMITTER USER’S MANUAL
Conductivity - Diagnostics Menu - Calibration Data 6.14
Conductivity - Diagnostics Menu - Calibration Data 6.14 Page 60
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
RUN MODE
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
The Calibration Data menu is a series of read only screens which
allow the user to view the data collected during the last calibration.
Calibration Mode
1 point calibration
Probe Temperature at which
calibration was performed =
25.2° C
Calculated Cell Constant
Conductivity of Buffer/
Input Resistance
Press to view the next
Calibration Data screen.
Press to view the first
Calibration Data screen.
TYPICAL DISPLAYS
FOR MANUAL CAL
Calibration Mode
Dry Cal
Dry Cal does not use a buffer, so
Probe Temperature was
not recorded
Cell Constant Setting
No Buffer used in
this Calibration Mode
Press to view the next
Calibration Data screen.
TYPCIAL DISPLAYS
FOR DRY CAL
CALIBRATION DATA
CALIBRATION DATA
CALIBRATION DATA
CALIBRATION DATA
CALIBRATION DATA
CAL TEMP 25.2C >
K FACTOR 0.9774 >
1P 1000/1000 >
MODE 1PT >
Ω
DIAGNOSTICS
CALIBRATION
UTILITIES
SETUP
FIRMWARE REV.
1000uS 25.0C
CALIBRATION DATA
CAL TEMP - - - - >
K FACTOR 1.0000 >
CALIBRATION DATA
1P - - - - >
MODE DRY >
CALIBRATION DATA
CALIBRATION DATA