Metex SharkTX Multi-Parameter Transmitters - Manual (Page 41)

ORP - Setup Menu - Temp. Display Override 5.9 Page 39
MULTI-PARAMETER TRANSMITTER USER’S MANUAL
ORP - Setup Menu - Temp. Display Override 5.9
UP
DOWN
DOWN
DOWN
DOWN DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN UP
DOWN
DOWN Use the or keys to
select either ON or OFF.
Press the key to accept the
change and move to the store function
Press the key once
which will move the cursor
back to the RH side of the
display.
Then press the key to store the
selection and return to the T. DISP
OVERRIDE Menu.
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the T. Disp. Override
Menu. This function is useful if you wish
to view the current selection without
making any changes.
If you wish to save the setting, press the
key to highlight the Y character
Not stored Stored
RUN MODE
Press the key once
which will move the cursor to
the ON or OFF text
T. Display Override is used to blank the Temperature Display
on the LCD menu and place 4 dots on the LED menu when
Temp display is requested.This is to ensure the user isn't
shown a temperature value that isn't valid.
STORE? Y N STORE? Y N
T.COMP OVERRIDE T.COMP OVERRIDE
AUTO RETURN
T. DISP OVERRIDE
CALIBRATION
UTILITIES
SETUP
500mV 25.0C
TEMP UNIT
TEMP SENSOR
PROBE SELECTION
OVERRIDE O FF >
OVERRIDE O N >
T. DISP OVERRIDE
T. DISP OVERRIDE
OVERRIDE ON >
T. DISP OVERRIDE
OVERRIDE OFF >
T. DISP OVERRIDE