Metex SharkTX Multi-Parameter Transmitters - Manual (Page 8)

3.1 Conduit Connections
The SHARK TX has two 1/2” conduit holes at the bottom of the enclosure as shown on fig. 2.1. The unit
is shipped with these holes plugged with liquid tight conduit seals. These must be left in unused holes
to maintain the NEMA 4X integrity. Use approved conduit hubs to connect the conduit, connect these
to the conduit before connecting to the enclosure.
3.2 Power Connections
Section 3 - Electrical Connections and Setup Page 6
MULTI-PARAMETER TRANSMITTER USER’S MANUAL
Section 3 - Electrical Connections and Setup
Figure 3.1 Connections
Dwg# N104-41