West Control Solutions N6600 - Manual (Page 58)

NOTES ON TABLE 5-2
1. These parameters cannot be modified whilst either the Pre-Tune facility or
the Self-Tune facility is activated.
2. The Controller Status byte has the following format:
3. Only Type 3 or Type 4 messages are allowed with this parameter. In the
Type 3 message, the {DATA} field must be one of eleven five-digit numbers.
The reply from the Controller also contains the {DATA} field with the same
content. When the master device issues the Type 4 message, the Controller
responds with the same {DATA} field content. The commands
corresponding to the {DATA} field value are:
00010 = Activate Manual Control 1
00020 = Activate Automatic Control 1
00030 = Activate the Self-Tune facility
00040 = De-activate the Self-Tune Facility
00050 = Request Pre-Tune 2
00060 = Abort Pre-Tune
00150 = Activate Output Turn-Off 3
00160 = De-activate Output Turn-Off 3
5-6 O075-5
PM-0075