West Control Solutions ProVU 4 - Manual (Page 113)

ProVU4 Controller, Profiler & Recorder/Controller - Product Manual
Page 112 Modbus Parameters 59407, Issue 1 – March 2008
Parameter Name Modbus Address Access Values
(Dec) (Hex)
Value Status Of Event 2
0 Event 2 Inactive
Event 2 Status 8250 0x203A RO
1 Event 2 Active
Value Status Of Event 3
0 Event 3 Inactive
Event 3 Status 8251 0x203B RO
1 Event 3 Active
Value Status Of Event 4
0 Event 4 Inactive
Event 4 Status 8252 0x203C RO
1 Event 4 Active
Value Status Of Event 5
0 Event 5 Inactive
Event 5 Status 8253 0x203D RO
1 Event 5 Active
Value Segment Type Status
0 No segment
1 Setpoint ramping up
2 Step
3 Dwell
4 Held
5 Loop
6 Join
7 End
Segment Type
Status 8258 0x2042 RO
8 Setpoint ramping down
Currently Active
Profile Name 8259 0x2043 RO The name of the currently selected profile
Value
0
Profile running
1 Input sensor break
2 Profile not valid
3 Controller in manual mode
4 Profile finished. Profiler is maintaining
the last profile setpoint
5 Profile finished with control outputs off
Secondary Profile
Status 8232 0x2028 RO
6 Profile control has ended. Unit is
Controller Mode.
Delay time 8233 0x2029 RO The current start delay time remaining
Current Profile
Running Time 8235 0x202B RO The elapsed time of the current running profile
Current Profile
Remaining Time 8236 0x202C RO The remaining time for the current running profile
Current Segment
Running Time 8237 0x202D RO The elapsed time of the current profile segment
Current Segment
Remaining Time 8238 0x202E RO The remaining time for the current profile segment
Total Hold Time 8239 0x202F RO Total time the current profile has been held
Current Segment
Loops Run 8240 0x2030 RO The number of times the current looping segment has
looped back
Profile Setup 8198 0x2006 R/W Refer to the Profile Setup Over Modbus
information below