West Control Solutions KS98-1 - Manual (Page 202)

APROG
Digital inputs (APROG):
hide
Display suppression (with hide = 1 the page is not displayed in the operation).
lock Adjustment blocking (with lock = 1 the values are not adjustable by means of keys ID).
run Program stop/run ( 0 = stop, 1 = run ) reset has highest priority
reset Program continue/reset (0 = continue, 1 = reset )
preset Program preset ( 1 = preset )
search Start programm search run (1 = search )
p-show Program editing enabled
halt
Program interruption (e.g. due to an exceeded bandwidth detected outside the programmer).
0 = program not halted
1 = program halted
manfree
Manual mode disabled
0 = switchover to manual mode not permitted
1 = switchover to manual mode is permitted
Digital outputs (APROG):
run
Status program stop/run (0 = program stop ; 1 = program run)
reset Status program reset (1 = program reset)
end Status program end (1 = program end reached)
fkey Status H key / interface function `fkey’ (:pressing key H causes switch-over (0 or 1))
preset
This output indicates a programmer preset operation. With a single preset command, a pulse is
output for the duration of one cycle (dependent on the time slot in which the programmer is clas-
sified). If the programmer is held in preset continuously, this output is always active.
0 = no preset status
1 = APROG stands in preset status
manual
This output indicates the progrmmer manual mode.
0 = APROG works in automatic mode
1 = APROG works in manual mode
Analog inputs (APROG):
PSet
Preset value for program
DBlock Block number of 1st data function `APROGD’
ProgNo Required program number (recipe)
XVal Value for search run
SlavNo
SlavNo:
Block number of a connected slave block (for coupling master and slave blocks (APROG or DPROG)
Programmer 9499-040-82711
III-202 APROG ( analog programmer (No. 24)) / APROGD ( APROG data (No. 25))
Operation
preparation
expired
program time
Program
START
Program
END
Time
Wp0
Operation
RESET
Process
value x
RESET
PRESET PRESET
Fig. 35