West Control Solutions KS98-1 User Manual
Page 222
Digital programmer operating page
Digital programmer DPROG has an operating page, which can be selected in the operating page menu with input
‘
hide‘ not connected. For changing the value of an entry field, this value must be marked using ID (inverse dis-
play). When acknowledging the value with M, it starts blinking and can be adjusted with ID. When reaching the re-
quired value, it must be acknowledged with M. If the FB inputs assigned to the input fields (function block inputs) in
the following table are allocated to the engineering, operation (change) of this input field is not possible.
Ü
*Program block name
*
Recipe name: recipe can be switched over in reset
status
Ö
Segment number: adjustable with segment preset
ä
*automatic / manual (adjustable)
#
*Page changing:
permits switching to an analog or digital page connec-
ted by block coupling. This switchover type applies only
to the values marked with *. The remaining display ele-
ments invariably show the master programmer values.
>
Control bit
y
*Control bits: can be altered individually in manual
mode.
x
Remaining
segment time: display is suppressed with preset to segment (e.g. with digital slave program-
mers). Otherwise the invariable overall segment time would be displayed.
c
*Program net time: adjustable with preset to time
v
Remaining program time
—
Programmer status stop / run / reset / program / quit / error
˜
halt / end (if none of the two conditions is active, this display remains empty)
DPROG program edit page
Like the analog programmer, changing from the operating page to the subordinated parameter page is done by setting
the status text shown at the bottom right to ’program‘ (possible only with p-show = 1). Display includes recipe name,
the 6 start control bits and the segment parameters of the instantaneously active recipe.
Switchover to display of a different recipe is by changing the recipe name. This is possible at any time and does not
cause switchover of the active recipe.
Ü
Name of program block
*
Recipe name:
Recipe changing is possible at any time .
Ö
Control bit status in reset mode
ä
Time for segment 1
#
Control bit status in segment 1
<
Time for segment 2
>
Control bit status in segment 2
y
:
Programmer
9499-040-82711
III-222
DPROG ( digital programmer (No. 27)) / DPROGD ( DPROG data(No. 28))
Ü
¡
£
¤
¥
|
x
c
b
v
m
n
Fig. 51
Ü
¡
¢
£
¤
¥
|
y
x
c
¤
¥
|
:
Fig. 52