West Control Solutions KS98-1 - Manual (Page 30)

I-8 Operation
The operation of the device is menu-guided. The menu is divided into several levels which can all be influenced via the
engineering, i.e. the final scope of the menu is dependent on the engineering.
This manual describes the operating functions which are independent of the engineering.
I-8.1 Front view
LEDs (
Ü¡¢£):
for indication of conditions determined by the engineering,
e.g. alarms or switching states.
HDIM keys (|–©¨):
Operation is by four keys for selection of pages and input on
pages.
DI
The two functions of keys up/down are:
– Navigation in menus and on pages
– Changing input values (e.g. )
M
The two significations of the selector key are dependent on
the selected field:
– Pressing the selector key (confirmation / Enter): starts page changing,
– starts value alteration via the up/down keys and confirms the adjustment subsequently ( r page 32).
H
The functions of the auto/manual key are dependent on operating page, i.e. this key is sometimes called function key.
– Controller: auto/manual switchover
– Programmer: programmer control
– Adjustment of digital values.
# Locking screw:
for locking the instrument module in the housing
< PC interface:
PC interface for engineering tool ET/KS98 and BlueControl. The tools permit structuring/soft-wiring/configurati -
on/parameter setting/operation.
y Display/operating page:
– LCD point matrix (160 x 80 dots),
– changeable green/red back lighting, direct/inverse display mode.
Display is dependent on configured functions.
Operation 9499-040-82711
I-30 Front view
–
Ü ¡ ¢ £ ¤
¥ |
y
x ©
Fig. 11