West Control Solutions KS98-1 - Manual (Page 39)

Controlling a program
Press key H to control the program sequence:
The time curve can be controlled also by changing the
elapsed time c or segment number £ (preset).
+ Dependent on engineering, parts of this operation may
be changed or disabled.
Program parameter setting
Select the program for editing via field "Rec" ¡. Call up the
relevant s/control values, segment times and types with
menu item “program” in the status line (field — ).
A page on which the selected program is displayed as
“RecEdt” is opened. The parameters are listed in the order
of segments.
The data blocks are displayed dependent on engineering.
The type of individual segments can be changed dependent
on data block type.
Selection of all programs including the inactive ones is
possible on line
RecEdt in any programmer status.
When using recipe names, these names are displayed on
the editing page. Switching over to the parameters of a dif-
ferent recipe can be done by altering the recipe name. This
is possible at any time and does not cause switchover of
the active recipe.
A segment list is completed with end identification
--:-- in parameter Tp
n
of the last segment. When set-
ting the last segment time T
n
to a valid value (higher or
equal to 0), the next parameter is displayed automatically
T
n+1
. = --:-- etc.
This procedure permits shortening of a current program by
adjusting a value < 0 in the required position for T
n
=
--:-- with key D.
The following segments will be suppressed in the program.
The relevant segment parameters remain unchanged and
can be re-activated by input of a valid value for T
n.
9499-040-82711 Operating pages
Programmer I-39
RUN
RUN
RESET STOP
END RESET
H H H
Rec = 1
Wp0 = Wert
Tp1 = Zeit
Wp1 = Wert
Tp2 = Zeit
Wp2 = Wert
Tp3 = Zeit
Wp3 = Wert
Tp4 = Zeit
.
.
.
Wpn = Wert
Tpn+1 = --:--
Ende
scrolling
Fig. 21
Parameter Step 1
Parameter Step 2