Alps Electric MD-1300 User Manual
Page 108
Chapter 2 - Various Printing Operations
106
Step 4
❿
❿
❿
❿
❿
1.
Click OK in the Print dialog box.
Printing will begin.
Step 5
❿
❿
❿
❿
❿
Transfer the Image to Paper with an Iron
Transfer the image to paper (using an iron) after printing on the
back print film is completed.
1.
Cut around the printed image as close to the edges of the
image as possible.
2.
Place the film on paper with the image in contact with the
paper. Place the finishing sheet on top and apply even
pressure with an iron.
Note
•
Use paper larger than the size of the image.
•
Taking care not to let the film slip, firmly apply pressure with
the iron until the image is completely attached to the paper.
Back Print Film fits on the paper
Back Print Film
Paper
Paper
Back Print Film
Back Print Film extends
beyond the edge of the paper
•
If insufficient pressure is applied to the image, bubbles can
form when the film is lifted off. Make sure to apply enough
pressure, particularly around the edges and corners.
•
Set the iron for 160°C/320°F (cotton). If the iron has outlet
holes for steam, set the iron to Dry and avoid the holes, using
a flat part of the iron.
Finishing Sheet
Back Print Film
Paper to transfer the image to
Finishing Sheet
Back Print
Film
Paper to transfer
the image to