Alps Electric MD-1300 - Manual (Page 116)

Chapter 2 - Various Printing Operations
114
Cloth the iron-on was transferred to
Finishing Sheet
3. Remove the iron-on transfer sheet after the cloth has
cooled completely.
Starting at the corners, make sure the iron-on is firmly attached
to the cloth, and then carefully peel off the rest of the sheet. If
the sheet does not come off cleanly, replace it, and then iron it
again.
4. Place the finishing sheet on the cloth with the silicon
coated side face down (with the cut corner in the upper
left corner). Apply the iron again to completely affix the
iron-on to the cloth.
Note
The finishing sheet can be used many times. Do not discard it
after using it.
5. Remove the finishing sheet after the cloth has cooled com-
pletely.
Caution
•
The iron-on should withstand many washings but if it should
begin to peel away again for some reason simply use the
finishing sheet again to reattach it.
•
Do not use dry cleaning. Also, the transferred image may
peel off in the laundry if the cloth stretches or shrinks a lot,
does not withstand heat well, or if the cloth has a nap. These
kinds of cloth should be avoided.
•
Note that once an iron-on has been applied it cannot be re-
moved.
•
Do not use bleach. Bleach may cause the colors in the printed
image to run.
•
Do not use the iron directly on the iron-on.
•
Do not dry in a dryer.