Alps Electric MD-1300 - Manual (Page 12)

10
Chapter 1 - Major Functions and Operations
Getting Your Printer Ready
Set up your printer by performing the following steps:
•
Getting your printer ready.
Remove the packing materials.
•
Connecting cables.
Connect the printer to your computer with a printer cable and to a suitable AC
power source with the power cord.
Getting Your Printer Ready
Get your printer ready by removing the packing materials from inside and outside
the printer.
Caution
This printer is shipped with tape, spacers, and other packing
materials to prevent delicate parts from being damaged while in
transit. Remove these packing materials before using the printer.
If the printer is used while these packing materials are still
present, damage to the printer or malfunction may occur.
Removing the outside packing materials
The printer is shipped with packing materials to prevent damage during transit.
Remove the tape (three locations in front) and cardboard from the printer before
using.
Cardboard
Tape