Agilent Technologies E8247C PSG CW - Manual (Page 78)

68 Chapter 3
Optimizing Performance
Creating and Applying User Flatness Correction
Save the User Flatness Correction Data to the Memory Catalog
This process allows you to save the user flatness correction data as in the signal generator’s memory catalog.
With several user flatness correction files saved to the memory catalog, any file can be recalled, loaded into
the correction array, and applied to the RF output to satisfy specific RF output flatness requirements.
1. Press
Load/Store
.
2. Press
Store to File
.
3. Enter the file name FLATCAL1 using the alphanumeric softkeys, numeric keypad, or the knob.
4. Press
Enter
.
The user flatness correction array file FLATCAL1 is now stored in the memory catalog as a UFLT file.
Applying a User Flatness Correction Array
Press
Return
>
Return
>
Flatness Off On
.
This applies the user flatness correction array to the RF output. The UF indicator is activated in the
AMPLITUDE section of the signal generator’s display and the frequency correction data contained in the
correction array is applied to the RF output amplitude.
Recalling and Applying a User Flatness Correction Array
Before performing the steps in this section, complete “Creating a User Flatness Correction Array” on
page 64 .
1. Press
Preset
.
2. Press
Amplitude
>
More (1 of 2)
>
User Flatness
>
Configure Cal Array
>
More (1 of 2)
>
Preset List
>
Confirm Preset
.
3. Press
More (2 of 2)
>
Load/Store
.
4. Ensure that the file FLATCAL1 is highlighted.
5. Press
Load From Selected File
>
Confirm Load From File
.
This populates the user flatness correction array with the data contained in the file FLATCAL1 . The user
flatness correction array title displays User Flatness: FLATCAL1 .
6. Press
Return
>
Flatness Off On
.
This applies the user flatness correction data contained in FLATCAL1.