Using the instrument state register, Using the instrument state – Agilent Technologies E8247C PSG CW User Manual

Page 64

Advertising
background image

54

Chapter 2

Basic Operation
Using Data Storage Functions

Using the Instrument State Register

The instrument state register is a section of memory divided into 10 sequences (numbered 0 through 9) each
containing 100 registers (numbered 00 through 99). It is used to store and recall instrument settings. It
provides a quick way to reconfigure the signal generator when switching between different signal
configurations. Once an instrument state has been saved, you can recall the instrument settings for that state
with minimum effort.

NOTE

List sweep data is not saved within an instrument state. For instructions on saving list sweep
data, see

“Storing Files to the Memory Catalog” on page 53

.

Saving an Instrument State

1. Preset the signal generator, then enables amplitude modulation (the

AM

annunciator will turn on):

a. Press

Frequency

>

800

>

MHz

.

b. Press

Amplitude

>

0

>

dBm

.

c. Press

AM

>

AM Off On

.

2. Press

Save

>

Select Seq

.

The sequence number becomes the active function. The signal generator displays the last sequence used.
Using the arrow keys, set the sequence to 1.

3. Press

Select Reg

.

The register number in sequence 1 becomes the active function. The signal generator displays either the
last register used accompanied by the text:

(in use)

, or (if no registers are in use) register 00

accompanied by the text:

(available)

. Use the arrow keys to select register 01.

4. Press

Save Seq[1] Reg[01]

.

This saves this instrument state in sequence 1, register 01 of the instrument state register.

5. Press

Add Comment to Seq[1] Reg[01]

.

This enables you to add a descriptive comment to sequence 1 register 01.

6. Using the alphanumeric softkeys or the knob, enter a comment and press

Enter

.

7. Press

Edit Comment In Seq[1] Reg[01]

.

If you wish, you can now change the descriptive comment for sequence 1 register 01.

After making changes to an instrument state, you can save it back to a specific register by highlighting that
register and pressing

Re-SAVE Seq[n] Reg[nn]

.

Advertising
This manual is related to the following products: