Agilent Technologies E8247C PSG CW - Manual (Page 95)

Chapter 4 85
Analog Modulation
Configuring the LF Output
To Configure the LF Output with a Function Generator Source
In this example, the function generator is the LF output source.
Configuring the Function Generator as the LF Output Source
1. Press
Preset
.
2. Press the
LF Out
hardkey.
3. Press
LF Out Source
>
Function Generator 1
.
Configuring the Waveform
1. Press
LF Out Waveform
>
Swept-Sine
.
2. Press
LF Out Start Freq
>
100
>
Hz
.
3. Press
LF Out Stop Freq
>
1
>
kHz
.
4. Press
Return
>
Return
.
This returns you to the top LF Output menu.
Configuring the Low Frequency Output
1. Press
LF Out Amplitude
>
3
>
Vp
.
This sets the LF output amplitude to 3 Vp.
2. Press
LF Out Off On
.
The LF output is now transmitting a signal using Function Generator 1 that is providing a
3 Vp swept-sine waveform. The waveform is sweeping from 100 Hz to 1 kHz.