Athena Technologies 16C - Manual (Page 18)

Input Used to select sensor-related parameters, such as input type,
limits, and scaling.
Display Used to set or change decimal position and display units.
Output Used to specify output usage, control methods, and alarms.
Control Used to select parameters associated with the control methods.
Alarm Used to select alarm parameters .
Note: This menu is also functional for controllers not
equipped with alarm hardware; however, alarm indication
will be only visual via the A1 and A2 LEDs on the front panel.
Tune Used to set the autotune damping parameter.
Recipe Used to set ramp and soak parameters.
Supervisor Used to set fail-safe and supervisory parameters.
Calibration Used to recalibrate input.
Option Used to select installed option.
Communications (Option) Used to set serial communications parameters.
Contact/Digital
Input (Option) Used to select switch input functions.
Remote Analog
Setpoint (Option) Used to enter remote analog setpoint parameters.
Auxiliary Output (Option) Used to set auxiliary output parameters.
14
Menus and Parameter
Descriptions
Menus and Parameters