Athena Technologies 16C - Manual (Page 21)

17
Display Menu
JMPØ1
Display Parameter Selection
Decimal Position 0-3 Linear Inputs
0-1 TC/RTD
Filter 0.1-10.0 sec
Units*
Fahrenheit
Celsius
Kelvin
*NOTE: Does not appear for linear inputs.
Blanking , 0-9999 sec
(Time selected before
setpoint diplay turns off.)
Output Menu
The first parameter that needs to be set in the Output Menu is the
Output Type. There are three possible Output Type configurations:
PID, On/Off, Alarm, or Off. (If you are not sure which Output Type
is best for your particular application, refer to the Glossary for an
explanation of Output Types.) The remaining menu parameters in the
Output Menu will change, depending on the Output Type selected.
The Control Menu will also change, depending on the Output Type
selected. If you ordered two outputs, you can select two different
Output Types. After setting your Output Type, refer to the correspond-
ing sections below for the remaining Output Menu parameters. For
simplification purposes, the following sections assume the same
Output Type for both outputs. If you selected different Output Types,
refer to both of those sections.
Output Type
Display Parameter Selection
Output 1 Type
Output 2 Type