Athena Technologies 16C - Manual (Page 27)

22 23
Recipe (Ramp/
Soak) Menu
Power Fail Resume
Setting this parameter to On will cause the control to resume
a recipe which was active when a power failure occurred. The
recipe will resume at the start of the last active ramp or soak
segment.
Ramp/Soak Events (1-8)
(If alarms are configured as ramp/soak events.)
Ramp/Soak events occur at the beginning of their designated
segment. All events are terminated once the recipe has been
completed or terminated. This can be used as an alarm when a
segment is reached.
Display Parameter Selection
Recipe Option Single-Setpoint
Ramp
Multi-Step Ramp
Disabled
Single-Setpoint 1-9999 mins.
Ramp Time*
*NOTE: Only available when single-setpoint ramp is selected.
Holdback Band Off-100 degrees
Termination State
Last Setpoint
Default Setpoint
Recipe to Standby
If a ramp/soak error
condition occurs, the
upper display will
toggle between
and the numeric error
code for three seconds
before the recipe
terminates. Possible
error codes are:
02 = Recipe Empty
(i.e. no non-zero ramp
times)
05 = Insufficient
Setpoint-Process Value
Deviation