Canon imagePROGRAF iPF605 - Manual (Page 103)

Printing procedure
9.
Send the print job.
• Printing from Windows (→P.92)
• Printing from Mac OS X (→P.93)
Start printing.
Note
• Steps 6 and 7 are not required, if a barcode has been printed on the roll and you have activated
automatic detection of the remaining roll paper. The paper type and amount of paper left are
automatically detected.
• Keeping a roll in the printer for a long time without printing on it may leave a depression on the leading
edge.
When printing quality is most important, we recommend setting TrimEdge Reload to On or Automatic
so that the paper edge is automatically cut before printing.
• For details on supported sizes and types of the roll that can be loaded, see “Paper Sizes” or the Paper
Reference Guide. (→P.106) (→P.101)
• Clean the platen after you have used up a roll. (→P.495)
• When a roll has been advanced, do not pull it out by force. This will prevent the paper from being
advanced. (→P.117)
If you accidentally pull out the paper, see “Roll Paper Cannot be Inserted into the Paper Feed Slot”.
(→P.514)
• When printing on rolls after printing on sheets, if the lit paper selection lamp does not switch from the
Cut Sheet lamp to the Roll Media lamp, press the Feeder Selection button.
Basic Printing Workow 89