Canon imagePROGRAF iPF605 - Manual (Page 433)

Network Setting
Conguring the IP Address Using the Printer Control
Panel
This topic describes how to congure the printer’s IP address on the Control Panel.
1.
Press the Menu button to display MAIN MENU.
2. Press ▲ or ▼ to select Interface Setup, and then press the ► button.
3.
Press ▲ or ▼ to select TCP/IP, and then press the ► button.
4. Press ▲ or ▼ to select IP Setting, and then press the ► button.
5.
Press ▲ or ▼ to select IP Address, and then press the ► button.
6. After pressing ◄ or ► to select the input eld, press the OK button to enable numerical input.
7. Press the ▲ or ▼ button to enter the value.
Note
• Pressing the ▲ button increases the number by 1. The maximum value is “255,” after which “0” is
displayed.
• Pressing the ▼ button decreases the number by 1. The minimum value is “0,” after which “255” is
displayed.
• Hold down ▲ or ▼ to increase or decrease the value continuously.
8.
Repeat steps 6-7 to enter the IP address assigned to the printer.
9. Press the Online button to bring the printer online.
If any of the settings are changed, a message for conrmation is displayed. In this case, press
the OK button.
Important
• Be sure to complete step 9. This will activate the values you have entered.
• You can also specify the subnet mask and default gateway on the Control Panel.
Note
• If an error message is displayed, check the settings and correct any invalid values.
• To cancel the setup process, hold down the Stop button for a second or more.
Network Setting 419