Canon imagePROGRAF iPF605 - Manual (Page 158)

Handling sheets
Loading Sheets Manually
When using the tray, load the paper in the Top Paper Feed Slot. (→P.144) However, if you have specied
POP Board, insert the sheet in the Front Paper Feed Slot. (→P.146)
Loading paper in the Top Paper Feed Slot
Note
• You can load only one sheet in the Top Paper Feed Slot. Do not load more than one sheet at a time.
This may cause paper jams.
• Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.
• Paper that is wrinkled or warped may jam. If necessary, straighten the paper and reload it.
• Load the paper straight. Loading paper askew will cause an error.
• Before feeding paper or printing, make sure the sheet is at against the Paper Tray Cover . The sheet
may jam if it curls before feeding or printing and the trailing edge drops toward the front.
• If a roll is loaded, rewind the roll before this procedure. (→P.138)
1. If you send a print job specifying a paper other than POP Board from a computer beforehand,
the type and size of paper are shown on the Display Screen. Press the Load/Eject button.
Note
• If you will load paper before sending a print job, press the Load/Eject button. After a menu for
selection of the type of paper is shown on the Display Screen, press ▲ or ▼ to select the type of
paper, and then press the OK button. Next, a menu for selection of the paper size is shown on the
Display Screen. Press ▲ or ▼ to select the size of paper, and then press the OK button.
2. Open the Paper Tray Cover (a), and then open the Tray Extension (b).
3. Slide the Width Guide (a) to align it with the mark for the size of paper you will load.
144 Handling Paper