Handling rolls, Selecting the paper source – Canon imagePROGRAF iPF605 User Manual
Page 123
Handling rolls
Handling rolls
Selecting the Paper Source
When advancing paper, press the Feeder Selection button and select the source.
You can determine the selected source by checking which lamp is lit-either the Roll Media lamp (a) or the
Cut Sheet lamp (b).
•
Roll Media lamp : Selected when printing on Roll Media.
•
Cut Sheet lamp : Selected when printing on Sheets from the Top Paper Feed Slot or Front Paper
Feed Slot.
Note
•
If any paper is loaded that will not be used, a message is shown on the Display Screen (either Remove
roll? or Eject sheet? ) when you press the Feeder Selection button.
To remove the paper, press the OK button. (→P.138)
•
You cannot switch the paper source in the following situations:
•
When the Message lamp is ashing
Check the message on the Display Screen and take action as necessary. (→P.535)
•
When the Data lamp is ashing
Select the paper source after printing is nished.
•
When a printer menu operation is in progress
Wait until the operation is nished before selecting the paper source.
•
When in the process of loading paper
Finish loading the paper before selecting the paper source.
•
When in the process of replacing ink tanks
Finish replacing the Ink Tank before selecting the paper source.
•
When the Top Cover is open
Close the Top Cover before selecting the paper source.
Handling Paper 109