110 chapter 7 problem solving enww – HP LaserJet 5200 Printer series User Manual
Page 122
Control panel message
Description
Recommended action
DATA RECEIVED
alternates with
Ready
The printer received data and is waiting for a
form feed. When the printer receives another
file, the message disappears.
The printer is paused.
If the printer is waiting for a form feed, press
to continue.
If the printer is paused, press
Stop
to
continue.
Event Log Empty
SHOW EVENT LOG was selected from the
control panel, and the event log is empty.
No action necessary.
Genuine HP supplies installed
A new HP cartridge has been installed. The
printer returns to the Ready state after
approximately 10 seconds.
No action necessary.
GENUINE HP SUPPLIES DESIGNED FOR
<PROD>
alternates with
Ready
This genuine HP supply was not designed for
this printer and is not supported. The printer
can print with this supply, but print quality
might be affected.
Replace this supply with a genuine HP supply
that is designed for this printer.
Incorrect
The PIN number is incorrect.
Contact the network administrator.
INFLATE FAILURE
An error has occurred during a firmware
upgrade.
1.
Reinstall the firmware.
2.
If the problem persists, contact
HP Support.
Initializing
This message appears when the printer is
turned on and begins initialization.
No action necessary.
Initializing permanent storage
This message appears when the printer is
turned on to show that permanent storage is
being initialized.
No action necessary.
INSERT OR CLOSE TRAY XX
A tray is open and the printer is trying to print
from another tray.
Close the tray indicated so that printing can
continue.
INSTALL FUSER
For help press
The fuser is either not installed or not
correctly installed in the printer.
Press for help.
or
Contact HP Customer Support or your
authorized HP service provider.
INSUFFICIENT MEMORY TO LOAD
FONTS/DATA
This message alternates with the name of the
storage device. The storage device does not
have enough memory to load the fonts or
other data.
Press
to continue printing without using
the data.
To solve the problem, increase the amount of
memory for the device. Press for more
information.
LOAD TRAY X <TYPE> <SIZE>
alternates with
For help press
Tray X is either empty or configured for a type
and size other than that specified in the job.
No other tray is available.
Press for help.
or
See
for more
information.
LOAD TRAY X <TYPE> <SIZE>
alternates with
To use another tray press
Tray X is either empty or configured for a type
and size other than that specified in the job.
Press for help.
or
110 Chapter 7 Problem solving
ENWW