HP LaserJet 5200 Printer series - Manual (Page 42)

Item Values Explanation
MANUALLY FEED PROMPT: Determines when the printer
shows a prompt regarding pulling from tray 1 if your print job
does not match the type or size that is loaded in any other tray.
● ALWAYS: Select this option if you always want to be
prompted before the printer pulls from tray 1.
● UNLESS LOADED: Prompts you only if tray 1 is empty.
PS DEFER MEDIA: Controls whether the PostScript (PS) or
HP paper-handling model is used to print jobs. ENABLED
causes PS to defer to the HP paper-handling model.
DISABLED uses the PS paper-handling model.
SIZE/TYPE PROMPT: Use this menu item to control whether
the tray configuration message and its prompts are shown
whenever a tray is opened and closed. These prompts instruct
you to set the type or size if the tray is configured for a type or
size other than the type or size that is loaded in the tray.
SLEEP DELAY 1 MINUTE
15 MINUTES
30 MINUTES
45 MINUTES
60 MINUTES
90 MINUTES
2 HOURS
4 HOURS
Sets how long the printer remains idle before it enters Sleep
mode.
Sleep mode does the following:
● Minimizes the amount of power that the printer consumes
when it is idle.
● Reduces wear on electronic components in the printer
(turns off the display backlight, but the display is still
readable).
The printer automatically comes out of Sleep mode when you
send a print job, press a printer control-panel button, open a
tray, or open the top cover.
The default setting is 1 MINUTES.
WAKE TIME MONDAY
TUESDAY
WEDNESDAY
THURSDAY
FRIDAY
SATURDAY
SUNDAY
Sets a “wake-up” time for the printer to warm up and calibrate
each day. The default for each day is OFF. If you set a wake
time, HP recommends setting an extended sleep delay time
period, so that the printer will not return to sleep mode soon
after waking.
PERSONALITY AUTO
PDF
PS
PCL
Selects the default printer language (personality). The possible
values are determined by which valid languages are installed
in the printer.
Normally, you should not change the printer language. If you
change it to a specific printer language, the printer will not
switch automatically from one language to another unless
specific software commands are sent to the printer.
The default setting is AUTO.
CLEARABLE WARNINGS JOB Sets the amount of time that a clearable warning appears on
the printer control-panel display.
30 Chapter 2 Control panel ENWW