HP StorageWorks XP10000 Disk Array - Manual (Page 182)

• CU:LDEV: CU and LDEV numbers for the CVS volume to be created. The default is blank.
NOTE:
If an LDEV number ends with # (for example, 00:01#), the LDEV is an external LU. For more
information about external LUs, see the HP StorageWorks External Storage XP user guide .
• Select LDEV No. area: Used to set LDEV numbers for the CVS volumes you are creating.
• Select CU No.: Select a CU number from the drop-down list. The default is CU 00. LDEV
number settings for the selected CU number appear in the Select LDEV No. table.
• Interval: When selecting more than one volume, use this list to set the interval between the
LDEV numbers to be assigned to the newly created volumes. The default value is 0. When you
select 0, consecutive LDEV numbers are assigned.
NOTE:
The value you specify as the interval between LDEV numbers counts only available LDEV numbers
and skips those that are not selectable.
• Select LDEV No. table: Displays LDEV numbers for the CU number selected from the Select
CU No. list. Gray indicates LDEV numbers that are not selectable, white indicates unused
LDEV numbers, and blue indicates available LDEV numbers. You can select an LDEV number
from the white LDEV numbers in the table. When you set the LDEV number, that LDEV number
becomes available and changes to blue.
NOTE:
LDEV numbers that are not selectable might already be in use or assigned to another emulation
group (grouped by 32 LDEV numbers) (see Table 38 ).
NOTE:
If an LDEV number ends with # (for example, 00:01#), the LDEV is an external LU. For more
information about external LUs, see the HP StorageWorks External Storage XP user guide .
Table 38 Emulation groups
Emulation group D-type (overseas PCM) emulation type
Group 1 3390-3, 3390-3A, 3390-3B, 3390-3C, 3390-9, 3390-9A, 3390-9B, 3390-9C,
3390-L, 3390-LA, 3390-LB, 3390-LC, 3390-M, 3390-MA, 3390-MB, 3390-MC
Group 2 3390-3R
Group 4 OPEN-3, OPEN-8, OPEN-9, OPEN-E
Group 6 OPEN-V
• CU number of another SLPR is used: When selected, you can select the number of an LDEV that
does not exist in the SLPR to which the parity group does not belong. When cleared, you can
only select the number of the LDEV in the SLPR to which the parity group belongs.
NOTE:
The CU number of another SLPR is used check box appears only when you log in as a storage
administrator and when there are two or more SLPRs.
• Back: Returns to Install CV pane (1).
• Next: Opens one of the following panes:
182 Custom Volume Size operations