HP StorageWorks XP10000 Disk Array - Manual (Page 193)

NOTE:
If a VDEV number starts with E (for example, E1-1-(1)), the VDEV belongs to a parity group that
consists of one or more external LUs.
NOTE:
If a VDEV number starts with V (for example, V1-1-(1)), the VDEV belongs to a parity group that
consists of one or more virtual volumes (V-VOLs).
• Emulation: Emulation type of the CVS volume to be created (OPEN-V).
• Capacity: CVS volume's capacity displayed in the unit selected from the Capacity Unit list in
the Make Volume pane (1).
• CU:LDEV: CU:LDEV number of the CVS volume to be created.
NOTE:
If an LDEV number ends with # (for example, 00:01#), the LDEV is an external LU. For more
information about external LUs, see the HP StorageWorks External Storage XP user guide .
NOTE:
If an LDEV number ends with V (for example, 00:00V), the LDEV is a virtual volume (V-VOL). For
more information about virtual volumes, see the HP StorageWorks Snapshot XP user guide .
• Back: Returns to the Make Volume pane (2) or Make Volume pane (3).
• OK: Registers the Make Volume settings, and returns to the Customized Volume pane.
• Cancel: Cancels the Make Volume settings, and returns to the Customized Volume pane.
Volume Initialize pane (1)
Use this pane to initialize CVS volumes other than OPEN-V.
Figure 102 Volume Initialize pane (1)
This pane has the following features:
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
193