HP StorageWorks XP10000 Disk Array - Manual (Page 206)

If the selected LDEV number's boundary area does not have an SSID, the SSID setting pane appears.
Go to step 8. If the selected LDEV number's boundary area has an SSID, go to step 10.
6. On the SSID setting pane, select the CU number.
7. In the Input SSID list, select a new SSID.
NOTE:
When you log in as a storage administrator and the SSID number of another SLPR is used
check box is selected, you can also enter an SSID in the Input SSID list.
8. Click Set. The SSID appears in the SSID field of the SSID setting area.
9. To set two or more SSIDs, repeat step 6 through step 8.
10. After setting all SSIDs, click Next. The Volume Initialize confirmation pane appears.
11. Verify that the information in the Volume Initialize confirmation pane is correct, and click OK.
A notation appears across the top of the pane indicating the volume has been initialized. The color
of the VDEV icon you manipulated in the Parity Group - LDEV tree changes from red to blue.
NOTE:
Setting changes are not yet implemented in the array. You cannot manipulate VDEVs
denoted by blue icons until you either apply the changes to the array or cancel them, but
you can initialize additional CVS volumes in VDEVs denoted by red icons.
12. To apply changes to the array, click Apply (or Cancel to cancel them).
NOTE:
If desired, you can make settings on the Make Volume function (see Re-creating CVs after
initializing the VDEV (Make Volume operation) ) before clicking Apply. If you click Apply
after making settings on the Volume Initialize and Make Volume functions, settings on these
functions are applied simultaneously to the array.
13. Click OK.
NOTE:
When the Volume Initialize operation starts, a notation appears across the bottom of the
pane indicating the progress and completion at the end of the operation.
Re-creating CVs after initializing the VDEV (Make Volume operation)
CAUTION:
The Make Volume function is a destructive operation. Data on the CVS volume being converted is lost
when the operation is complete. You are responsible for backing up data as needed before performing
this operation.
CAUTION:
An error message might appear if Volume Initialize and Make Volume operations are performed
concurrently. For this error message, the part code is 0003 and the error number is 1041. If this message
appears, ensure that these operations are performed separately.
206 Custom Volume Size operations