HP StorageWorks XP10000 Disk Array - Manual (Page 197)

Figure 104 Volume Initialize pane (3) for confirming Volume Initialize settings
This pane has the following features:
• CVS volume-setting information table: Displays a list of the CVS volumes to be initialized.
• VDEV: VDEV number for the CVS volume to be initialized.
NOTE:
If a VDEV number starts with E (for example, E1-1-(1)), the VDEV belongs to a parity group that
consists of one or more external LUs.
NOTE:
If a VDEV number starts with V (for example, V1-1-(1)), the VDEV belongs to a parity group that
consists of one or more virtual volumes (V-VOLs).
• Emulation: Emulation type of the CVS volume to be initialized.
• Capacity: Capacity of the CVS volume to be initialized, either in MB for open-system volumes
or cylinders (Cyl) for mainframe volumes.
• CU:LDEV: CU:LDEV number of the CVS volume to be initialized.
NOTE:
If an LDEV number ends with # (for example, 00:01#), the LDEV is an external LU. For more
information about external LUs, see the HP StorageWorks External Storage XP user guide .
NOTE:
If an LDEV number ends with V (for example, 00:00V), the LDEV is a virtual volume (V-VOL). For
more information about virtual volumes, see the HP StorageWorks Snapshot XP user guide .
• Back: Returns to the Volume Initialize pane (1) or Volume Initialize pane (2).
• OK: Registers the Volume Initialize settings, and returns to the Customized Volume pane.
• Cancel: Cancels the Volume Initialize settings, and returns to the Customized Volume pane.
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
197