HP Command View for Tape Libraries Software - Manual (Page 126)

2. In the navigation panel under Policies, select Tapes for verification. A list of tapes due for data
verification appears. These are tapes that have a policy for data verification and they have
reached or exceeded that policy time period. The table includes:
•
Barcode — The barcode of the tape cartridge.
•
Verification date — The date and time the last data verification test was performed.
•
Last Result — The last data verification test result.
•
Policy name — The policy applied to this particular tape.
•
Days overdue — The number of days elapsed from the date the tape exceeded its policy.
•
Action Recommended — A message based on the location of the cartridge is shown. If
the cartridge is in the data verification partition, the message is Move to Queue. If the
cartridge is outside the data verification partition, the message is Move to DV
Partition
.
3. Click Queue Tapes. This opens a window displaying the tapes that are already in the data
verification partition.
4. Select the tapes that you want to test and click OK. This moves them to the queued state for
testing. Once tested, the results are available on the Results window (see
“Viewing the test
results for Data Verification” (page 127) ) and via email if you set up the email notification (see
“Setting up data verification email notifications” (page 126) ).
You can also select the tapes to test from the Test Setup Details screen; see “Adding, removing,
and changing tapes from the queue” (page 125) .
Setting up data verification email notifications
Data verification email notifications allow you to receive email alerts when data verification
determines that data should be migrated to a new tape because the tape is bad. You configure
the data verification notification at the library level. When you receive a data verification email
notification, the subject line is “cartridge migration notification.” The body of the email lists the
serial number of the library, the bar code of the tape requiring data migration, the total amount
of data verified (in MB), the run time of the test (in minutes), and the verification result.
NOTE: You must have permanent CVTL and data verification licenses to enable data verification
email notification. Perform any SMTP configurations before enabling data verification email
notifications.
1. In the Launcher window, navigate to the Administration panel.
2. Select Actions
→Enable DV E-mail Notification. This opens the DV Email Notification wizard.
126 Command View TL GUI