HP Command View for Tape Libraries Software - Manual (Page 138)

NOTE: Review the downloading instruction in the release notes before upgrading the firmware.
•
Command View TL 3.5.00 cannot upgrade any libraries with i240 or older Interface Manager
firmware. Upgrade to 2.8.00 then install the bundle. Once the installation of 2.8.00 is
complete, install Command View TL 3.5.00.
•
If upgrading or downgrading the ESL E-Series library from a revision less than 4.86, download
and install revision 4.86 to the ESL E-Series library before you download the latest ESL E-Series
library code. Otherwise the smart media or Daughter card will need to be replaced.
•
You must be at the I232 and 2.32 firmware bundle or higher before proceeding with the
upgrades to the I273 and 3.1.00 firmware bundle. If at a revision lower than I232 or 2.32
firmware bundle first migrate to I232 and 2.32 firmware bundle to proceed. You have to be
at i250 or above to download with Command View TL 3.1.00.
•
If the EML library is below 1200 download 1200 first. Then if the EML library is below 1407
download 1407 first. Otherwise the RLC might need to be replaced.
To update the Interface Manager card firmware:
1.
In the Library window, click the Support tab.
2. In the left panel, select Firmware Update. A list of components appears in the right panel. If
any components need updating, Yes appears in the Update Available column.
3. Select Actions
→Launch Firmware Update Wizard.
The welcome screen of the Firmware Update wizard appears.
4. Read the warning, and then click Next. The Selection page of the Firmware Update wizard
appears.
138 Command View TL GUI