HP Command View for Tape Libraries Software User Manual
Page 137
To move media:
1.
In the Library window, click the Operations tab.
2.
In the left panel, click Media Management. A list of the locations of all the tape cartridges
appears in the right panel.
3.
To launch the Move Media wizard, select Actions
→Move Media.
Source Media page of the Move Media wizard appears.
4.
On the first page of the Move Media wizard, select the source location, and then click Next.
The selected source should be FULL, if it is not a validation error occurs. The Next button
remains disabled and is enabled only if the selected source media is full.
5.
On the second page, select the destination location, and then click Next. The destination must
be EMPTY or a validation error occurs. The Next button remains disabled and is enabled only
if the selected destination media is empty.
6.
If the selected source and destination are incompatible then a warning message immediately
occurs.
7.
On the third page, verify that the source and destination locations are correct and read the
warning. If you are satisfied with your choices, click the check box to indicate that you
understand the warning, and then click Next to proceed with the move. If you are not satisfied
with your choices, click Back to make changes, or click Cancel to exit the wizard without
performing the move.
8.
The final page of the wizard displays progress information. When the move is successfully
completed, click Finish to complete the wizard.
If an error occurs, the appropriate error message displays in the wizard page. Click Finish to
close the wizard.
Updating the firmware with the Firmware Update wizard
HP recommends that you always use the latest firmware for all the components in the library.
Command View TL provides a convenient Firmware Update wizard to help you manage firmware
revisions.
CAUTION:
Make sure that all applications that access the library or drives are shut down until
the firmware update is complete. Do not interrupt the firmware update process. Stopping this
program or powering down the component during the update could cause the component to be
inoperable and require physical repair.
Updating the firmware with the Firmware Update wizard
137